The software allows you to read and write EEPROM and FLASH in engine control units, read and write the contents of the immobilizers EEPROM via diagnostic connector OBD II.Engine control units (ECU)
List of supported engine control units:
- BOSCH M1.5.5
- Siemens Simtec 7.1
- Siemens Simtec 7.1.1
- Siemens Simtec 7.1.5
- Siemens Simtec 7.1.6
- Delco Multec HSFI-C
- Delco Delphi HSFI
- Delco Multec HSFI 2.0-2.5
- Delco Delphi Diesel
- Denso 1.7
- BOSCH EDC15
- BOSCH EDC16
- BOSCH PSG16
Also there is the possibility of purchasing tuned firmwares for engine controls units.
First generation OPEL imoobilizer (IMMO1)
Reading and writing the contents of the EEPROM via diagnostic connector OBD II
Also available a functions of keys learning, reading mechanical key code and VIN.
In some cases, access to the memory of the immobilizer can be blocked. In this case you will need to close pin of the microcontroller once, then the program will receive full access and in the future will not need to open the immobilizer. All functions are performed through the diagnostic connector.
This software requires an adapter CEE-Team Special Interface.
